![]() NOTE: your monitoring interface may be called something other than wlan1mon. Use the following command to do a survey of all of the Wi-Fi access points and clients that are within range of your machine: I would recommend reading the text instructions as well but lots of people find these videos useful: Airmon-ng & Airodump-ng Here is a video of the process from installing the software to beginning the scanning process. This brings the Monitor Mode Wi-Fi interface back up so that we can use it for the rest of the tutorial: Bring Monitor Mode Interface Back Up Permanent MAC: 00:25:22:XX:XX:XX(ASRock Incorporation) 4 macchanger OutputĬurrent MAC: 00:25:22:XX:XX:XX (ASRock Incorporation) Get into the habit of doing this each time you run the process. The reason we are changing the MAC address is to get rid of any permanent identifiers. Will output following command, do not be tempted to set a random MAC address permanently. Ifconfig wlan1mon down Temporarily change your MAC Address Take Down Monitor Mode Interface Temporarily You can change the MAC address of your computer with macchanger. Changing your MAC address is a very basic step that you can take. But if you intend to start a career in penetration testing, then developing the habit of routinely masking your computers identity and not leaking any personally identifiable information will serve you well. Now, I know that you’ve got full permission to go after this particular access point so you might wonder why you need to mask your computers identity by changing the mac address. (mac80211 station mode vif disabled for wlan1) (mac80211 monitor mode vif enabled for wlan1 on wlan1mon) Phy1 wlan1 rt2800usb Ralink Technology, Corp. To find out if your radio is connected run the following command in your Terminal: That being said it’s time to find whether the RPi recognises your USB Wi-Fi radio. On the RPi the interface named wlan0 3 tends to be the Wi-Fi radio on the RPi itself and whilst it’s possible to use the on-board Wi-Fi in Monitor Mode, you will have much better results (with range and signal strength etc) with the USB Wi-Fi radio. Sudo apt install macchanger Hunt the Radio! Sudo apt install aircrack-ng Install macchanger Sudo apt install iw Install Aircrack Suite Sudo apt install wget and curl Install iw macchanger To give us a random MAC address.aircrack-ng For grabbing handshakes and attempting to guess the password.iw For monkeying with network connections.wget & curl For grabbing things from the Internet. ![]() Install The Necessary Softwareįirst need to install the software we are going to need to Hack all the packets! The software packages we are going to install our: I’ve tried loads of them but I always end up coming back to the Alfa AWUS036NHA USB Wi-Fi radio. You will also need a Wi-Fi adapter that you can put into Monitor Mode, on this version of the RPi it is possible to do that but I would definitely recommend splashing out the 20 to 30 quid on an Alfa USB Wi-Fi radio. It’s important to use the light version as it doesn’t contain anything you don’t need. This post assumes you have a Raspberry Pi 3B+ (RPi) running the operating system Raspbian Stretch Lite. Text Video or Picturesĭepending on what type of learning you prefer it might be easier for you to watch a video of this process, that video is at the end of this post. What you should do is learn this stuff and make your networks, and any network you are responsible for, that much more difficult to pop. If you’re just learning to hack, follow this simple principle: do not hack things without permission 2: I am not a lawyer, I am not your lawyer and you really shouldn’t do anything stupid or bad with the information contained in this post. This tutorial is intended for you to test YOUR OWN NETWORK INFRASTRUCTURE AND HARDWARE OR NETWORK INFRASTRUCTURE and hardware you have specific permission to audit 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |